Different ramp times, or different set temps, or both? Some of the controllers allow you to store multiple settings.
Mark On 08/03/2016 07:12 AM, John Thornton wrote: > For my powder coat oven I need different recipes for different coatings > so a simple temperature controller won't work for me. > > JT > > > On 8/2/2016 11:22 PM, John Kasunich wrote: >> With everyone pitching in on what they think is the best controller, >> I'll put my two cents in... >> >> If you are doing this as a learning exercise, or to get better with >> LinuxCNC, then by all means do it and enjoy. But if you just want >> a working oven, get a DIN temperature controller and move on >> with your life. >> >> Sub $20 >> https://www.amazon.com/AGPtek%C2%AE-Digital-Temperature-Controller-Alarm/dp/B005NGL5AK >> >> I haven't studied specs for that particular one, but there are >> tons of them out there with capabilities ranging from rudimentary >> to far better than you'll likely cook up unless you spend weeks >> writing code. >> >> John Kasunich >> > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
