Or a $5 nano from AliExpress...
On 8/2/2016 1:56 PM, Curtis Dutton wrote: > Hi everyone, > > > I'm in the middle of designing a paint curing oven for my shop. I am going > to control it with linuxcnc. The oven only runs at 120 Degress Farenheight > ~ 50 Deg Celsius > > > So far I plan on using LM35's for temperature reading. A 120V 1500W heating > element driven with a solid state relay. > > > I would like to use a 7i92 ethernet board along with a 7I66-8 serial card > for IO. > > I can use the analog reading capability of the 7I66 to read my temperature > sensors. > > I have a couple of questions. Can I hook the 7i92 directly to the 7i66 > without needing an in-between card due to the fact that the 7i66 is a > serial card? > > > I think that this is possible, but would I be able to run one of the output > pins at 60HZ PWM to drive the heating element? > > I suppose that I could do a HAL component PWM and just hook it up to a 7i66 > pin. > > > Also any suggestions for a mini PC that can run linux. Even just a > motherboard would be fine, especially if I can power it from 24V DC and > mount it inside of my enclosure. I'd prefer to remain with x86 arch. > > > > Thanks, > Curt > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
