On 08/03/2016 12:22 AM, John Kasunich wrote: > With everyone pitching in on what they think is the best controller, > I'll put my two cents in... > > If you are doing this as a learning exercise, or to get better with > LinuxCNC, then by all means do it and enjoy. But if you just want > a working oven, get a DIN temperature controller and move on > with your life. > > Sub $20 > https://www.amazon.com/AGPtek%C2%AE-Digital-Temperature-Controller-Alarm/dp/B005NGL5AK > > I haven't studied specs for that particular one, but there are > tons of them out there with capabilities ranging from rudimentary > to far better than you'll likely cook up unless you spend weeks > writing code. > > John Kasunich > I've got the Honeywell version of that on my bamboo heat treating convection oven. It keeps the oven temp within + or - 1 degree Fahrenheit of the set temp.
Mark ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users