----- Original Message ----- > From: "Valerio Bellizzomi" <[email protected]> > To: "Enhanced Machine Controller (EMC)" <[email protected]> > Sent: Tuesday, June 27, 2017 3:58:34 AM > Subject: Re: [Emc-users] steppers with encoders in closed loop > > I have the P parameter set to 1000 and the motors are quiet. > Previously > pncconf had set P to 10000 and the motors made noise like hell and > vibrated.
P = 1000 Will usually only work for an open loop stepper setup using the sudo feedback from the hardware stepgen. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
