What hardware are you runing this on. I assume just a generic STM32F board?
On Sun, Dec 3, 2017 at 10:19 AM, Nicklas Karlsson < nicklas.karlsso...@gmail.com> wrote: > > > I just got firmware downloaded on STM32F303 start but have not yet tested > anything. > > Oddly enough in SystemWorkbench from ST Microelectronics I had to use > manual load command "monitor flash write_image erase > DieBieSlave-Firmware.elf" and run openocd separately. This is not the case > on another card with same Micro controller I have. > > I am thinking a little bit of the copyright issue since there are no > license anywhere. I found two malloc I have removed so now there should be > no memory allocation on the heap. > -- Chris Albertson Redondo Beach, California ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users