On Thursday 14 December 2017 09:23:56 andy pugh wrote: > On 14 December 2017 at 13:49, Gene Heskett <[email protected]> wrote: > > However Andy, I had assumed that parport was not the interface > > needed for that ISA card. What then is the linuxcnc name for that > > driver? > > https://github.com/LinuxCNC/linuxcnc/blob/master/src/hal/drivers/pcl72 >0.comp > > man pcl720 should give you the manpage. > > The same driver could probably be persuaded to run your Futurelec > cards with very minor changes.
Unfortunately, I sent all 3 of them to someone about 15 or 16 years ago, who promised to write an emc2 driver for them. Never even got a thank you email back. So I wrote them off as a very expensive lesson long ago. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
