Thanks Jon, >From the sound of if, the powers that be are not going to let me convert this >machine to Linuxcnc. They want to buy a new Wincnc PC. (The machine >operators and myself would rather switch it over.) Oh well.
Todd Zuercher P. Graham Dunn Inc. 630 Henry Street Dalton, Ohio 44618 Phone: (330)828-2105ext. 2031 -----Original Message----- From: Jon Elson <el...@pico-systems.com> Sent: Wednesday, October 09, 2019 9:27 PM To: Enhanced Machine Controller (EMC) <emc-users@lists.sourceforge.net> Subject: Re: [Emc-users] Mesa Card Suggestions On 10/09/2019 10:06 AM, Todd Zuercher wrote: > Jon, > > What would be the approximate cost estimate for your setup? > > Oh, the two stepper controller boards can be "daisy-chained" on one parallel port. If you buy both at the same time, I will throw in the daisy chain cable for free. You will need an EPP (IEEE-1284) parallel port on the computer. Jon _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users