Gene, just make it executable and run the appImage. I use Cura to slice for a Delta-printer and use LinuxCNC (actually, Machinekit on a Beaglebone) to drive the hardware. Marlin on Arduino hardware works nicely too, of course. Good luck with 3D-printing, just needs the usual learning curve. Karl
Am 02.06.2020 um 18:37 schrieb Gene Heskett: >> When I go to the Cura downloads page it lists - Ultimaker Cura 4.6.1 >> Linux, 64 bit >> >> https://ultimaker.com/software/ultimaker-cura >> > Ok, I'll bite, what the heck is an apimage? Better yet, what do I do > with it on linux? Debian 9.8 TBE, all up to date. _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users