> On Sun, 7 Jun 2020 at 14:47, N <nicklas.karlsso...@gmail.com> wrote: > > > Modig MD6000. > > > > There is one here doing tool-changes with LinuxCNC. > https://www.youtube.com/watch?v=SkAjD2iKizU > It isn't clear from the noises if it is a hydraulic or pneumatic clamp... > > But, this message on the forum from the same chap says that the clamp is > hydraulic: > https://forum.linuxcnc.org/24-hal-components/29153-vmc-related-hal-questions?start=110#67391
Tried it today but still could not get chuck inside. Hydraulic pump had some effect, applying valve on hydraulic and chuck stuck even though not fully inside and could be released by pumping up pressure but with only tip locked on inside it can't work. Guess I have to disassemble to figure out what might be wrong. Regards Nickklas Karlsson _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users