Wow: that's a beauty. Did you give it a wax and polish to get that shine? Marcus
On 22 Jun 2020, at 09:23, andrew beck wrote: > Hey guys. I bought the vertical machining centre! > > Bringing it home tomorrow then into the retro hopefully. > > Here are some photos > > https://photos.app.goo.gl/Qdf89ubgfqixenaH8 > > > > > > Regards > > Andrew > > On Sun, Jun 7, 2020, 4:54 AM Jon Elson <el...@pico-systems.com> wrote: > >> On 06/06/2020 06:47 AM, andrew beck wrote: >>> hey andy >>> >>> my motor feedback type is a fanuc incremental encoder. i think it is a >> sin >>> cos. >> If this is the 10S motor you are talking about, it has >> traditional differential TTL quadrature plus index, plus 4 >> commutation signals that repeat 4 times per revolution. >> Yes, it is an 8-pole motor. >>> I did go throught it and checked that it was not a serial encoder a >>> couple of months ago but I wil try dig the info out later I think it is >>> 2048ppr >> No, the 10S is not available with 2048 pulses. Your choices >> are 1000, 2000, 2500, 3000 and 10,000. >> >> >> Jon >> >> >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users