On Fri, 25 Dec 2020, Gene Heskett wrote:
Date: Fri, 25 Dec 2020 15:03:43 -0500
From: Gene Heskett <ghesk...@shentel.net>
Reply-To: "Enhanced Machine Controller (EMC)"
<emc-users@lists.sourceforge.net>
To: emc-users@lists.sourceforge.net
Subject: [Emc-users] for PCW
Greetings and Merry Christmas.
The 7i76 manual has mention of modes 0, 1, and 2 for reading the analog
voltages applied to the first 4 inputs.
But no place in that lengthy manual does it mention how to switch it so
this mode 1 is enabled so as to enable that ability.
The hostmot2 man page has the information
basically you set the mode with a token/value pair
in the hm2_xxx driver command line like:
sserial_port_0=23xxxxxx
(this sets sserial port 0 channel 0 to mode 2 and channel 1 to mode 3)
And it does output a 0-9.9 volt signal for a 0 to 397 HZ input on the
vfd's VO terminal. So where do I put this mysterious "mode 1" ???
Thanks Peter.
Cheers, Gene Heskett
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
If we desire respect for the law, we must first make the law respectable.
- Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/gene>
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
