Trying to use the index functionality is adding a layer of complexity you don't need. Just and the 2 switches together and run them into the home input.
On Sun, Apr 4, 2021, 10:44 AM Feral Engineer <[email protected]> wrote: > That might be worth a try. > > Is it safe to load the build bot master repository on a pi? > > Phil T. > The Feral Engineer > > Check out my LinuxCNC tutorials, machine builds and other antics at > www.youtube.com/c/theferalengineer > > On Sun, Apr 4, 2021, 11:38 AM Dewey Garrett <[email protected]> wrote: > > > The git *master* branch has an ini setting that may be relevant > > for this use case: > > > > http://linuxcnc.org/docs/master/html/config/ini-config.html > > > > "HOME_INDEX_NO_ENCODER_RESET = NO - Use YES if the encoder > > used for this joint does not reset its counter when an > > index pulse is detected after assertion of the joint > > index_enable hal pin. Applicable only for HOME_USE_INDEX = YES." > > > > Refs: > > > > https://github.com/LinuxCNC/linuxcnc/commit/5ea573adde > > > > Also see forum thread starting here: > > > > > https://forum.linuxcnc.org/10-advanced-configuration/31813-tcp-5-axis-kinematics?start=120#139881 > > -- > > Dewey Garrett > > > > > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
