I did it from the buildbot buster repository and it worked a treat 😊 Phil T. The Feral Engineer
Check out my LinuxCNC tutorials, machine builds and other antics at www.youtube.com/c/theferalengineer On Sun, Apr 4, 2021, 12:35 PM Gene Heskett <ghesk...@shentel.net> wrote: > On Sunday 04 April 2021 11:42:24 Feral Engineer wrote: > > > That might be worth a try. > > > > Is it safe to load the build bot master repository on a pi? > > > > Phil T. > > The Feral Engineer > > > Sure, I'm doing git pulls and building master on a pi4, 6 to 10 times a > week. Then installing the debs built. Works fine. > > > Check out my LinuxCNC tutorials, machine builds and other antics at > > www.youtube.com/c/theferalengineer > > > > On Sun, Apr 4, 2021, 11:38 AM Dewey Garrett <dgarr...@panix.com> wrote: > > > The git *master* branch has an ini setting that may be relevant > > > for this use case: > > > > > > http://linuxcnc.org/docs/master/html/config/ini-config.html > > > > > > "HOME_INDEX_NO_ENCODER_RESET = NO - Use YES if the encoder > > > used for this joint does not reset its counter when an > > > index pulse is detected after assertion of the joint > > > index_enable hal pin. Applicable only for HOME_USE_INDEX = YES." > > > > > > Refs: > > > > > > https://github.com/LinuxCNC/linuxcnc/commit/5ea573adde > > > > > > Also see forum thread starting here: > > > > > > https://forum.linuxcnc.org/10-advanced-configuration/31813-tcp-5-axi > > >s-kinematics?start=120#139881 -- > > > Dewey Garrett > > > > > > > > > > > > _______________________________________________ > > > Emc-users mailing list > > > Emc-users@lists.sourceforge.net > > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > If we desire respect for the law, we must first make the law respectable. > - Louis D. Brandeis > Genes Web page <http://geneslinuxbox.net:6309/gene> > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users