> From: gene heskett [mailto:[email protected]] > On 2/12/26 12:06, John Dammeyer wrote: > > HI all, > > This popped up on my amazon feed. > > https://www.amazon.ca/InnoView-Portable-Touchscreen-10-Point- > Protective/dp/B > > 0DFLZTG9W/ref=sr_1_6?th=1 > > > > > > Listed as 15.6" 1080P with 10 point touch screen. Is something like this > > usable with LinuxCNC and one of the Touch Screen interfaces? > > Thanks > > > > John > Funny you should ask John, just last week as I was bringing up s sovol > sv08 MAX printer, which has a separate hdmi interface made to be able to > tweak the hundreds of settings klipper as a printer driver gives you via > its http control interface.� I'd bought a 7" color TFT monitor, called a > 10.1" in Merican format adv. but had no x config settings.� And stumbled > over a post on stack exchange that looked promising, so I modified 3 > lines of it and replaced the spaceholder with that.� Works perfectly, > 1st try.� So the info is out there if your google foo works.� Plug the > touchscreen output into a usb port and cat /dev/input/event# to see > where the touch data is output, there may be several event0-thru event9 > depending on the usb discovery of your system. You will get several 12 > byte repeating sequences of output per fingertouch In debian 11 which is > the os for this svo08 MAX printer, see > /etc/X11/xorg.conf.d/01-dbbian.defaults,conf and it looks like this at > the bottom of it now: There are other entry's above this but this is > what changed. #Section "InputClass" # Identifier "touchscreen catchall" > # MatchIsTouchscreen "on" # Option "CalibrationMatrix" "-1 0 1 0 -1 1 0 > 0 1" #see the X11 manpage but this is section is in swahili. #EndSection > Section "InputDevice" Driver "evdev" Identifier "touchscreen" Option > "Device" "/dev/input/event0" #edit the 0 to match the src you found > Option "Name" "touch screen" #Option "GrabDevice" "true" Option > "InvertY" "true" Option "Calibration 0 1024 0 600" #edit to suit your > screens pixels by pixels Option "Emulate3Buttons" "true" Option > "Emulate3Timeout" "50" EndSection I hope this is a bit of help John. > > _______________________________________________
Cool. Thanks Gene. John _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
