Thanks. That's what I've done in the past I suppose, but I've never had a project with nearly this many.
Can anyone think of any pitfalls to rigging a dummy empty staff for tempo markings and including it in the parts? It seems that would be a hell of a lot easier, especially with this many parts. On Feb 22, 2010, at 1:03 PM, SN jef chippewa wrote: > >> Custom smart line. > > make sure they extend the entire length instead of just on the current page > (i.e. work in scroll view) > > copy to all parts using mass copy filter set only to measure-attached shapes. > however, do NOT copy this to parts where smart shapes are present in the > measure region. in those cases, make a single measure line taht can be > copied in the same way, or do them manually. one important thing to note in > how this works. if you have a cresc hairpin spanning mm 1-3 and copy a > measure-attached line that spans only m1 or mm 1-2 it will not erase the > cresc. > > thelonger lines will disappear in MM rest, in the cases where you see this > will happen, create one manually (or create a version to copy) whcih spans > ONLY within the 1st measure of what will become the MM rest before copying, > that way it will still appear in the part. you will have to manually adjust > in these cases.<snip> _______________________________________________ Finale mailing list Finale@shsu.edu http://lists.shsu.edu/mailman/listinfo/finale