Oops I had CWL set. When switched to CWU the 9600 synchronizes properly. Ed W2RF
-----Original Message----- From: Flexedge [mailto:[email protected]] On Behalf Of Andrew O'Brien Sent: Saturday, May 11, 2013 8:36 PM To: Neal Campbell Cc: [email protected]; SkimmerTalk Reflector Subject: Re: [FlexEdge] PowerSDR and CW Skimmer not aligned I assume it is default, says... CW Pitch 600 (Hz) On Sat, May 11, 2013 at 8:32 PM, Neal Campbell <[email protected]> wrote: > What cw tone are you using in PSDR? > 73 > Neal Campbell > Abroham Neal LLC > > HUGE DAYTON CELEBRATION SALE!! > Time to get the guaranteed setup for your SDR! > Now until end-May > > > > On Sat, May 11, 2013 at 8:04 PM, Andrew O'Brien <[email protected]>wrote: > >> Returning to this topic after a week break to rest my brain. I >> tampered with the "IF audio" setting in CW Skimmer. After trial and >> error, I now have CW Skimmer and PowerSDR aligned , the IF Audio >> setting that works is >> 4500 Hz instead of 9600 Hz. I have no idea why, nor any idea what >> issues changing it will cause, but my skims are aligned now. >> Andy K3UK >> >> >> On Wed, Apr 24, 2013 at 9:49 PM, Andrew O'Brien <[email protected]> >> wrote: >> >> > I have got PowerSDR and CW Skimmer working together, the frequency >> > displayed in PowerSDR is the same frequency in the main >> display >> > of CW Skimmer. However a CW signal nicely centered in PowerSDR >> > does not show in the CW Skimmer waterfall at all. CW signal DO >> > show in Skimmer's waterfall, but not ones heard in PowerSDR's >> > audio. When CW Skimmer >> lists >> > a CQ call in Call List, it is about 20 Khz off from PowerSDR. I >> > Googled this issue and found some folks with similar issues in >> > 2011. VAC >> settings >> > were suspect at that time but I did not see a solution , some said >> > the issue went away when VAC was updated to a new version. I am >> > using the latest version and have VAC set up identical to the Flex >> > Knowledge Base screenshots on using CW Skimmer. I note with >> > interest the fact that CW Skimmer has a Frequency Calibration >> > option that is grayed out when I use PowerSDR. . >> > >> > Anyone have an idea or two on where to start? >> > >> > Andy K3UK >> > >> _______________________________________________ >> Flexedge mailing list >> [email protected] >> http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz >> This is the FlexRadio Systems e-mail Reflector called FlexEdge. It >> is used for posting topics related to SDR software innovation and >> other technical SDR topics. >> > > _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software innovation and other technical SDR topics. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software innovation and other technical SDR topics.
