i have a hunch that losing the pin movement on the schem was to allow
orcad import
i groused at first but agree it is the better tradeoff
Dennis Saputelli
Ian Wilson wrote:
> Protel used to allow pin numbers to be edited on the sch but no
> longer. The Update Sch process in PCB is not able to create macros that
> re-route the Sch wires. End result - you have to do this manually. At
> least until someone writes an automatic re-wire server.
>
> On balance, I think I am against being able to edit the pin numbers on the
> sch due to the increased chances of stuffing up a design. I am very much
> for Protel continuing to increase the integrity of the design process even
> possibly at some (minor) loss of flexibility.
>
> Ian Wilson
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
