Den 01.10.2023 06:56, skrev Valmor F. de Almeida:
On 9/30/23 17:25, Håkon Alstadheim wrote:
Den 30.09.2023 22:57, skrev Valmor F. de Almeida:
Hello,
For a while now (3 weeks or so) I have been upgrading the linux
kernel on a Dell XPS laptop starting from 6.1.41-gentoo (which is my
current working kernel) to 6.1.53-gentoo-r1. No kernel I have built
since is able to boot. I have been following the same method for
many years: make oldconfig, etc...
The booting error starts at:
[snip]
* INIT: Entering runlevel: 3
[snip]
* Starting cronie ...
* Starting DHCP Client Daemon ...
* Starting laptop_mode ...
* Mounting network filesystems ...
/etc/init.d/netmount: line 45 /lib/rc/bin/ewend: Input/output error
/lib/rc/sh/rc-cgroup.sh: line 184: rmdir: command not found
INIT:
INIT: cannot execute "/sbin/agetty"
INIT: cannot execute "/sbin/agetty"
INIT: cannot execute "/sbin/agetty"
Can you show /etc/fstab and the console-log for the entire boot?
Seems /sbin is not readable. You sure you have the kernel modules
loaded? Are you using an initramfs? If so, does that build without
errors ?
Here is fstab:
/dev/nvme0n1p2 /boot ext2 defaults 0 2
/dev/nvme0n1p3 none swap sw 0 0
/dev/nvme0n1p4 / ext4 noatime,discard 0 1
/dev/cdrom /mnt/cdrom auto noauto,user 0 0
I have not changed anything from 6.1.41-gentoo (which compiles and
boots) except updating the config file for compiling the new kernel.
Then I do: make && modules_install. Which runs without errors. After
that: grub-mkconfig -o /boot/grub/grub.cfg.
I am not using initramfs.
I can't see anything fishy in fstab, no network-mounts that might have
failed. From the original message it looks like your network interface
is not being set up correctly, but you should still be able to boot.
Also "rmdir: command not found" probably means your PATH does not get
set, or else you don't have execute permissions on rmdir. Odd that this
should be dependent on kernel version. You should go over and verify
that the transfer of your linux .config went OK. Then verify that the
new config does in fact enable modules for your network card, and enable
the necessary settings for your init system (looks like you are using
openrc?)
