The X'20' bit has to be set ? Sent from my iPhone
> On Mar 3, 2014, at 7:45 PM, Paul Gilmartin <paulgboul...@aim.com> wrote: > >> On Mon, 3 Mar 2014 19:21:20 -0500, Micheal Butz wrote: >> >> Now that you bought it up I think ISPF has a table ISPTCM where you specify >> authorized command it's in the ISPF customization guide > Hmmm. Didn't know about that. I see: > > > http://pic.dhe.ibm.com/infocenter/zos/v1r12/topic/com.ibm.zos.r12.f54pc00/isptcm.htm > > ... > ENTRY > Parameter values are as follows: > ENTNAME > A valid TSO command name. This operand is required for ENTRY calls. > The alphabetic characters in ENTNAME must be in uppercase letters. Duplicate > entry names cause an error message to be issued. > > Sounds like a command processor. Command processors are subtly > different from ordinary programs, although I believe either is found > in the STEPLIB/TASKLIB/ISPLLIB concatenation. > >>>> On Mar 3, 2014, at 7:14 PM, Paul Gilmartin wrote: >>>> On Mon, 3 Mar 2014 19:05:29 -0500, Micheal Butz wrote: >>>> >>>> Is your program in a APF authorized library link edit with AC=1 >>>> >>>> You can also use the SPKA instruction if the The only thing you desire to >>>> do is change the PSW storage key > > OP was trying for KEY 7. That may be harder. > >>> Additionally: see: >>> >>> >>> http://pic.dhe.ibm.com/infocenter/zos/v1r12/topic/com.ibm.zos.r12.ikjb400/usmi.htm >>> >>> to run authorized under TSO, a program must be named in the AUTHPGM NAMES( >>> ... ) >>> section of SYS1.PARMLIB(IKJTSOxx). ISPF may impose further constraints. > > --gil > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
