On Sunday 09 May 2010 23:49:49 Joep Suijs wrote: > Hi Florin, > > Looks very nice, the perferct evaluation board for developers ;) Thanks. > > Some point to concider for even more improvement: > - What would be nice is a led or two, but there are four in a combined > way and you may run out of pins... In my application I use PWM1,2 for diversion resistor (shunt regulator) and Power1,2 for protection (relay command). In the future I plan to use PWM1, PWM2, and Power1 Power2 for a bridge in H. > - And if you make e.g. jumper 1 to 4 a dip-switch, you can use it as a > on/off switch. I was looking to put dip switch. It is good idea, variable resistors may be used as a pullup or pulldown. > - And last but not least: it would be nice to have a pushbutton or > two, they are more easy to read than a keyboard. With a resistor from > 5V to the colums lines will do. If I find space? I try to use the 4-5 buttons. > - And about those column lines: is there a reason they are on the > higher half of port D and not the lower half? The latter can be freed > with a character display if you use 4 bit mode... Now I have no reason. But you're right and thank you for the idea. > What is the use of the ne555? For measuring frequency (rpm windmill, wind speed) > What will be the size of this shield? And would it be usable on an > arduino board? Is 75x85 mm, standard jaluino shield. But exist in jaluino/shields an adaption for Arduino shields. > > Joep > > 2010/5/9 Florin Tanasa <[email protected]>: > > Hi guys > > I try to make a shield for jaluino with: > > GLCD, LCD, Keypad, PWM, analog input, etc. > > This shield will be used mainly to develop a controller / logger for > > alternative energy systems (wind and solar) and other projects. > > My request is to look and say what you think about the scheme. > > Kind regards, > > -- > > Florin Tanasa > > http://sites.google.com/site/florintanasa/ > > > > -- > > You received this message because you are subscribed to the Google Groups > > "jallib" group. To post to this group, send email to > > [email protected]. > > To unsubscribe from this group, send email to > > [email protected]. For more options, visit this group > > at http://groups.google.com/group/jallib?hl=en. >
-- Florin Tanasa http://sites.google.com/site/florintanasa/ -- You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/jallib?hl=en.
