Steve: I am following Mark Langford's lead and making the deck removable but nither of the (3) different plans sets I have address the atachment details.
This project that I took over has the lower mount to firewall hols in the proper location but the uppers do not match probably done for a 4 pt. attachment commonly used for conv. geared versions but since this is to be a tri-gear the mount was built to allow for a top mount starter position on a Diehl Case. I guess I will use some 1/8" thk alluminum between the wood and a washer and then castle nut & cotter pin. Should get the Nose Gear from Diehl within a week or so Thanx Don ------------------------------------------------------------------------ Steve Glover wrote: > Unless you are making your forward deck removable, I would highly > recommend installing nut plates on aluminum plate. At some point you may > want to remove the engine mount. > > Regards, > > Steve Glover > KR-2 N902G > AJO, Ca > <kr...@cox.net> > > -----Original Message----- > The question I have is what is used on the interior firewall side, > Larger washers for wood, aluminum plates, Reg. AM washers or what? Then > do we use stop nuts or Castle nuts with cotter pins? > > _______________________________________ > Search the KRnet Archives at http://www.maddyhome.com/krsrch/index.jsp > to UNsubscribe from KRnet, send a message to krnet-le...@mylist.net > please see other KRnet info at http://www.krnet.org/info.html
