On 4/8/2026 5:03 PM, Phillip Matheson via KRnet wrote:
you may have missed what I getting at, my 0200 is . 2500 flat out down hill??with 59x 66 ?  At least you can dial yours back to 24 or 2500.
With the climb prop, 3000 rpm at 100kts
I may have to put the high compression pistons back in , ( but they caused other oil problems. At the moment it has new cylinders, standard pistons and compression ( leakage test @ 78/80 on all cylinders

Almost a waste of all that time building it to only fly at 100kts.
May I need to try another engine. But that’s a lot of work!!!!!!!!
Phil

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

Phil,

I can feel your disappointment all the way to southern Illinois, USA !!!  BUT, I can't imagine your airspeed disappointment is 0-200 related unless it has a major unidentified problem.  Until proven otherwise I'm betting it's the prop or an extremely low reading ASI.

Many years ago, I started with an aged 0-200 (1800 hours since factory overhaul) and a Ed Sterba 60D X 68P propeller.  I thought I should be able to pull a bit more rpm so I returned it to Ed for re-pitch to a 64P.  I couldn't tell any difference when I got it back so I'm not sure of the "exact" pitch.  I was topping out right at 2800rpm wide open at altitude.  I accepted that as near ideal as the engine is rated 100hp at 2750 rpm and I didn't want to stress a tired old engine.  I was indicating a quite accurate airspeed of 153 mph at 2500rpm.  I thought that was doing good considering 211LF is a 24" stretch with raised canopy, longer gear legs with RV wheel covers at a power setting the same as flying a C150.

Is there anyone in your part of the world with an 0-200 using a prop that is pulling good rpm on a fast airplane? Zach is still running that Sterba 60D X 68P? with over 1000+ hours with only refinish or two.

I would suggest you verify (sounds dumb) tach rpm with a hand held tach checker.  Verify "full throttle".  Verify mag timing at 28* BTDC with new cylinders.  If all that is spot on it has to  be the prop.  Does anyone in the area have a ground adjustable prop to try?  By the way, do you have wheel covers yet?  No wheel covers will cost you 12MPH+ at cruise.  If your engine runs really cool you may be pushing too much (draggy) air through the cowl.  I closed the inlets down pretty small on 211LF and it still ran really nice temps.

It's a KR!! Don't give up on it.  Treat it like a fine lady and give it what it wants.......................................

Larry Flesner

--
KRnet mailing list
[email protected]
https://list.krnet.org/mailman/listinfo/krnet

Reply via email to