At 05:30 PM 9/12/02 +0100, Luis.F.Correia wrote:
>Ray,
>
>you are right in most of your affirmation.
>
>I had done it ONCE using EigerStein and an 3Com Etherlink
>3 ISA (I think...)
>
>The command I used to change the MAC was:
>
>ip link set eth0 address ff:ff:ff:ff:ff:ff
>
>You will need to change the FF... to the correct MAC that
>you want to fake.
[...]
Thanks for the prompt feedback, Luis. Yes, this is the "ip" command
involved. The corresponding "ifconfig" command is
ifconfig hw ether ff:ff:ff:ff:ff:ff
Now we just need a decent list of which NICs will act on the MAC-address
change thus made, at the firmware level. (This assumes that the module will
accept the command; not all do.) Luis has nominated one candidate, the 3Com
Etherlink 3 ISA. Others, anyone?
--
-------------------------------------------"Never tell me the odds!"--------
Ray Olszewski -- Han Solo
Palo Alto, California, USA [EMAIL PROTECTED]
-------------------------------------------------------------------------------
-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf
------------------------------------------------------------------------
leaf-user mailing list: [EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/leaf-user
SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
