I'll try later today on my Intel Pro100 PCI, just for a sanity check.
-----Original Message----- From: Ray Olszewski [mailto:[EMAIL PROTECTED]] Sent: Thursday, September 12, 2002 6:38 PM To: [EMAIL PROTECTED] Subject: RE: [leaf-user] LRP Bering / change nic mac address At 05:30 PM 9/12/02 +0100, Luis.F.Correia wrote: >Ray, > >you are right in most of your affirmation. > >I had done it ONCE using EigerStein and an 3Com Etherlink >3 ISA (I think...) > >The command I used to change the MAC was: > >ip link set eth0 address ff:ff:ff:ff:ff:ff > >You will need to change the FF... to the correct MAC that >you want to fake. [...] Thanks for the prompt feedback, Luis. Yes, this is the "ip" command involved. The corresponding "ifconfig" command is ifconfig hw ether ff:ff:ff:ff:ff:ff Now we just need a decent list of which NICs will act on the MAC-address change thus made, at the firmware level. (This assumes that the module will accept the command; not all do.) Luis has nominated one candidate, the 3Com Etherlink 3 ISA. Others, anyone? -- -------------------------------------------"Never tell me the odds!"-------- Ray Olszewski -- Han Solo Palo Alto, California, USA [EMAIL PROTECTED] ---------------------------------------------------------------------------- --- ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html