I've just always hit enter 2x and accepted whatever MAC address CP comes up with. Is anything working on this layer2 vswitch yet? Can you see the server - what does Q VSWITCH DET show?
Marcy "This message may contain confidential and/or privileged information. If you are not the addressee or authorized to receive this for the addressee, you must not use, copy, disclose, or take any action based on this message or any information herein. If you have received this message in error, please advise the sender immediately by reply e-mail and delete this message. Thank you for your cooperation." -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Adam Thornton Sent: Tuesday, November 25, 2008 7:09 AM To: LINUX-390@VM.MARIST.EDU Subject: Re: [LINUX-390] SLES 10 SP 2 - Starter Vswitch On Nov 25, 2008, at 7:52 AM, Shedlock, George wrote: > Gentle Listers, > > I have the SLES 10 SP2 starter system build and am attempting to > create my first guest from the starter system. I start the install > process, console log follows: > [...snip...] > Any suggestions? How very strange. I'm going to guess that the answer is in the MAC address specification. You gave it 101095. Is it perhaps expecting colons between the bytes? Does it want you to specify all six bytes, even though the first three are defined by CP? I don't remember, and I don't have a Layer 2 guest LAN/VSWITCH handy to test on right now. Does anyone remember off-hand? Adam ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
