Well, I took your advice and dist-upgraded Ray. Now I know why I was not very anxious to do it :). A problem occured with kernel modules during the dist-upgrade. From memory, it was something like the new modules couldn't be configured until after the system was rebooted: somehow the fact that the running kernel was using modules was going to interfere. The message made it sound like this generation was going to be done automatically on next boot (and it was pretty stern about warning me to reboot). I took that advice: however, also in the wake of the dist-upgrade there was a lilo problem. I've got sort of a complex boot menu, and decided I'd need to get in there and hand-edit it. I did. But, as fate would have it, I made a minor goof-up and couldn't fully boot when I sent the system down (the initrd.img symlink wasn't pointing to the right initrd.img). But I did manage to reboot with the old kernel after the new one rebooting failed and to straighten out that mistake. It was at that point that I spotted the fearful message "eth0 ERROR while getting interface flags: no such device." And, sure enough, there was no net connection. And there was no process automatically running to straighten out whatever module problem had occured in the dist-upgrade. Tried booting a yet older kernel, but with the same eth0 error. Thinking maybe the card had gone south, I booted Knoppix (can someone send that guy a purple heart or something?). eth0 came up fine under Knoppix. I ran lsmod there to see what modules my NIC is using. Booted back to the dist-upgraded Debian, modprobed those modules and ran ifup -a - and here I am on the 'net again. But this is obviously not the real solution to the problem. This has all been a long-winded preface to the question: what the heck I gotta do to get my NIC modules back to loading on boot? Am I gonna run into other module problems as well? What's the way to start this process that gets the module loading routine working as it should be? I think there was a reference to modules.dep or maybe modules.conf in that message I saw during dist-upgrade. But there was definitely nothing there telling me how I could manually start the process that couldn't finish during dist-upgrade. Any pointers, please?
Thanks, James PS Most of the above refers to having booted using the new kernel (2.6.6, though some of those boots were with the old 2.6.5 kernel and one was even with the 2.4.22 kernel). None of those were able to use eth0 and gave the same error message during the boot process. - To unsubscribe from this list: send the line "unsubscribe linux-newbie" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.linux-learn.org/faqs
