John, The only fix I've seen for the i810 and agp memory is to increase system memory on the workstation. 64mb will work just fine.
It does seem that there should be a better way to fix it though. You might try adding 'VideoRam 4096' in your XF86Config file. As for the mouse problem, you will need to edit your XF86Config.ws001 file and change the mouse port to '/dev/psaux'. Hope that helps, Jim McQuillan [EMAIL PROTECTED] On Thu, 28 Feb 2002, John Ingleby wrote: > Hi, > > I'm new to this list, and fairly new to Linux and LTSP, but I hope someone > can answer this. > > For my terminal I'm using a BK-01 Book PC with 400MHz Celeron and 32Mb. > After adding the line XSERVER = "i810" in lts.conf, my Book PC boots up and > starts loading X, but then the screen flashes before showing the following: > > (WW) I810(0): 8192k of memory was requested, but the maximum AGP > memory available is 3068k > (EE) I810(0): Less than 6MB of AGP memory available. Cannot proceed. > > How can I reduce the memory requested by LTSP? (or, better, increase AGP > memory available on the Book PC?) > > Unfortunately, there is very little information about Book PC, so I tried > loading X with the line XF86CONFIG_FILE = (X86Config file) in lts.conf. This > ran into problems locating the PS/2 mouse, and the boot-up stopped on: > > (EE) xf86OpenSerial: Cannot open device /dev/mouse > > How could I modify the X86Config file to fix that? > > BTW the Book PC was marketed as a "Home Entertainment Centre", and it will > make a nice little diskless terminal when everything works and the fan is > quietened! > > Thanks in advance for your help, > > John Ingleby > ************ > > > > > > > > > > _____________________________________________________________________ > Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto: > https://lists.sourceforge.net/lists/listinfo/ltsp-discuss > For additional LTSP help, try #ltsp channel on irc.openprojects.net > -- _____________________________________________________________________ Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto: https://lists.sourceforge.net/lists/listinfo/ltsp-discuss For additional LTSP help, try #ltsp channel on irc.openprojects.net
