Mark,
I use the monotorque head gaskets.I also use chrome acl rings on acl
pistons.These are best used on a fresh bore.My current L20b has 60,000 hard
miles on it.It has never seen under 15lbs boost.I did a comp test last week(150
all round) which sounds about right for a low comp motor.Ideally forged pistons
would be the go with the sort of power my engine is putting out combined with an
o-ringed copper head gasket but that will have to wait.
Andrew Smith
mark krawczuk wrote:
> hi, cant remember if i posted this message before, but what is the best sort
> of rings , and head gasket to get for a l20b turbo motor?
>
> mark
> ]
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
