Hmmm, 3 sensors then? The one I was looking at is on the passenger side lower than the leading edge of the exhaust manifold just aft of the water pump. When grounded with the key on the aux fan runs.
T'other one is on top just forward and drivers side of the valve cover, when grounded it makes the fan clutch clunk. Tonight I will look for a third sensor where you describe. -Curt Date: Tue, 14 Aug 2012 20:29:39 -0700 (PDT) From: Frederick Moir <fredy4.s...@yahoo.com> To: Mercedes Discussion List <mercedes@okiebenz.com> Subject: Re: [MBZ] High temp, bad sender? Message-ID: <1345001379.54957.yahoomail...@web125001.mail.ne1.yahoo.com> Content-Type: text/plain; charset=iso-8859-1 Curt. Drivers side under the manifold about middle of the head, just above the block/gasket division. There is an hex boss that the sensor screws into. Of course I've been watching "Looney Tunes" again. Why do you ask? ? Fred Moir Lynn MA Diesel preferred. >________________________________ > From: Curt Raymond <curtlud...@yahoo.com> >To: Diesel List <mercedes@okiebenz.com> >Sent: Tuesday, August 14, 2012 9:56 PM >Subject: Re: [MBZ] High temp, bad sender? > >The continuing saga: > >I wondered if grounding one end would send the temp gauge high so I took a >jumper wire out with me. Fred had it backwards, the passenger side temp sensor >is in charge of the aux fan, the top side one is for the electo-magnetic fan >clutch. I can actuate either by grounding its associated connector with my >ground wire but neither affects the gauge at all. > >Does the system compares the output of the two to control the gauge? I didn't >think to ground both of them, I'd need to make up another jumper wire. > >The wire to the aux fan sensor has something wrong with it, I can turn the fan >on by wiggling the connector, I can't do the same with the fan clutch sensor. >Fortunately the wire is a jumper, it goes into the loom over by the fuel >filter. It does look like the connector comes apart, when I have more time >I'll see whats up with it. I'll also email Rusty, it'd be great if I could >just buy a replacement... Anybody got a 201 parts car? > >-Curt _______________________________________ http://www.okiebenz.com For new and used parts go to www.okiebenz.com To search list archives http://www.okiebenz.com/archive/ To Unsubscribe or change delivery options go to: http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com