Hi, Sam,
I've always preferred 'xf86config' for configuration of X. See if that
helps. Good luck,
Hidong
Sam Roza wrote:
>
> Hello All,
>
> I am new to the list, and am having difficulties.
>
> Last night I tried to install Linux-mandrake and it went GREAT, until I got
> to X setup. I just can't seem to get my settings right. I am installing on
> a Compaq Deskpro P166 with a soundblaster(this worked in the installation)
> and a Cirrus logic video board(I don't know what chipset or RAM).
>
> The first time I loaded it, I got into KDE(X?) but the screen was so messed
> up I couldn't use it, and I couldn't find a way to reset the video
> settings. I was reserved and I ended up re-installing linux a few times
> before I got a successful install.
>
> Now that everything is complete, and I can use unix(with my limited
> knowledge of unix it is difficult for me), from a console to be ROOT, and
> run Xconfigurator. After setting up Xconfig with my monitor's settings, and
> having it probe my adapter(when it probes, the specs sound right), but then
> the test screen comes up and asks "Can tyou read this message?" and I can
> read the message, but the boxes below are all skewed...
>
> I got it looking decent and selected yes when it asked my if I could see
> the message. Now it freezes when going into X...PLEASE HELP!!
>
> Regards,
>
> Sam Roza
> Lead Customer Service Representative
> (408) 527-2926
> GE Capital - IT Solutions
> [EMAIL PROTECTED]
