I have a problem with my HD external (Philips, and running on WinXP) because I can't access to the hd. No device is created. I thought that /dev/sda it's created. When I insert the two usb connector (one for data and the other for power) the dmesg is :
usb 3-2: new high speed USB device using ehci_hcd and address 6 scsi2 : SCSI emulation for USB Mass Storage devices usb-storage: device found at 6 usb-storage: waiting for device to settle before scanning Here I must wait for 10-20 Seconds and after hub 3-0:1.0: over-current change on port 1 usb 3-2: reset high speed USB device using ehci_hcd and address 6 scsi: Device offlined - not ready after error recovery: host 2 channel 0 id 0 lun 0 usb-storage: device scan complete When I connect only the data connector : hub 3-0:1.0: over-current change on port 1 usb 3-2: new high speed USB device using ehci_hcd and address 7 scsi3 : SCSI emulation for USB Mass Storage devices usb-storage: device found at 7 usb-storage: waiting for device to settle before scanning Here I must wait for 10-20 Seconds and after usb 3-2: reset high speed USB device using ehci_hcd and address 7 scsi: Device offlined - not ready after error recovery: host 3 channel 0 id 0 lun 0 usb-storage: device scan complete So the Log it's quite the same, and the results too. The modules for usb are loaded : ehci_hcd 31016 0 ohci_hcd 20804 0 usbcore 111644 7 usb_storage,usblp,usbmouse,usbhid,ehci_hcd,ohci_hcd sg 35676 0 usb_storage 82756 0 scsi_mod 123784 2 sg,usb_storage Thanks for any support Stefano Negro ____________________________________________________ Want to buy your Pack or Services from Mandriva? Go to http://store.mandriva.com Join the Club : http://www.mandrivaclub.com ____________________________________________________
