Alle 08:57, sabato 22 aprile 2006, SnapafunFrank ha scritto: > stblack at linux.it wrote:
> I have such a hard drive ( that works fine ) but you trouble me with > this two usb thing. Basically the lead offers two ways you can connect, > one for when you are supplying power to the hard drive directly and the > other when you are not. My point here is that I believe only one ought > to be connected ????? not both ! > > > > When I connect only the data connector : > > > > hub 3-0:1.0: over-current change on port 1 > > usb 3-2: new high speed USB device using ehci_hcd and address 7 > > scsi3 : SCSI emulation for USB Mass Storage devices > > usb-storage: device found at 7 > > usb-storage: waiting for device to settle before scanning > > > > Here I must wait for 10-20 Seconds and after > > > > usb 3-2: reset high speed USB device using ehci_hcd and address 7 > > scsi: Device offlined - not ready after error recovery: host 3 channel 0 > > id 0 lun 0 > > usb-storage: device scan complete > > > > So the Log it's quite the same, and the results too. > > The modules for usb are loaded : > > > > ehci_hcd 31016 0 > > ohci_hcd 20804 0 > > usbcore 111644 7 > > usb_storage,usblp,usbmouse,usbhid,ehci_hcd,ohci_hcd > > sg 35676 0 > > usb_storage 82756 0 > > scsi_mod 123784 2 sg,usb_storage > > As written here when I connect only one cable, the data cable, nothing changed. Stefano ____________________________________________________ Want to buy your Pack or Services from Mandriva? Go to http://store.mandriva.com Join the Club : http://www.mandrivaclub.com ____________________________________________________
