One of the biggest problems you're going to have with this is that even though Wifi is a big battery hog, constantly refreshing geolocation is an even bigger battery hog. While I don't have an application that can do this, my inclination would be to use something along the lines of Bluetooth proximity devices, possibly along the lines of two proximity devices along your path to the exterior door. When the proximity devices sense in one direction, you set one state, while if the proximity devices trigger in the opposite order, you set the opposite state.
Alternately, you could use a state table whose values were triggered on/off either by a code entered into your desk phone, your cell phone (with an appropriate password), or even by time-based signals (think cron job). On Mon, Mar 30, 2015 at 2:37 PM, Chris McQuistion <cmcquist...@watkins.edu> wrote: > Curt and I were discussing this idea this morning and it seems so obvious > that I'm sure someone is already doing this and there are probably already > some good ways of accomplishing this. > > Here's the idea. > > When I'm at work, I'd like our phone system (Asterisk-based Elastix) to just > route incoming calls over to my cell phone number, instead. I've got > unlimited minutes and it is always on me. > > When I leave work, I'd like the call routing to route to my desk phone, as > usual. > > It seems like this shouldn't be too hard to accomplish. If nothing else, > IFTTT could be used with the iOS Location or Android Location channel to > determine my geo-location. From there, I have to DO SOMETHING with that > information, and then have Elastix act on it. > > This is where I'm stuck. My best ideas so far are to create a new file in > Dropbox or append a line in a Google Spreadsheet when I'm entering or > leaving the geo-location. This seems a little kludge-y to me. > > Anyone got a better idea of how to accomplish this goal? It isn't really > important. It's just one of those ideas that I've had for a long time and I > can't seem to let it go until I figure out how to do it... > > Chris > > -- > -- > You received this message because you are subscribed to the Google Groups > "NLUG" group. > To post to this group, send email to nlug-talk@googlegroups.com > To unsubscribe from this group, send email to > nlug-talk+unsubscr...@googlegroups.com > For more options, visit this group at > http://groups.google.com/group/nlug-talk?hl=en > > --- > You received this message because you are subscribed to the Google Groups > "NLUG" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to nlug-talk+unsubscr...@googlegroups.com. > For more options, visit https://groups.google.com/d/optout. -- Tilghman -- -- You received this message because you are subscribed to the Google Groups "NLUG" group. To post to this group, send email to nlug-talk@googlegroups.com To unsubscribe from this group, send email to nlug-talk+unsubscr...@googlegroups.com For more options, visit this group at http://groups.google.com/group/nlug-talk?hl=en --- You received this message because you are subscribed to the Google Groups "NLUG" group. To unsubscribe from this group and stop receiving emails from it, send an email to nlug-talk+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.