If the CLI on your HP 2910 is anything like the other HP products I've used it's pretty straightforward.
If you want it to route between VLANs 10 and 11: ip routing vlan 10 ip address 172.30.10.1/24 vlan 11 ip address 172.30.11.1/24 In this case 172.30.10.1 and 172.30.11.1 would be the default gateways for the respective subnets. "Port forwarding" is only relevant if you are also doing NAT. On 1/24/2011 12:49 PM, Steve Ens wrote: > I usually use the CLI for initial config, setting up an IP address, name > it, etc. But then I turn to the java gui if I need anything else. I'll > dig into the CLI a little to see what is possible. I have a 10.0.0.x/24 > network that needs to have access to certain ports on a server that is > on a 192.168.1.x/24 network. Corporate Lan -> broadcast network. > Should be easy, and should work with a simple router, BUT the > application involved apparently needs to see the IP address directly, so > I'm not even sure that port forwarding will work. I may need to pull > the machines off the corporate LAN and stick them on the "other side", > and then give them access to the corporate LAN. -- Phil Brutsche p...@optimumdata.com ~ Finally, powerful endpoint security that ISN'T a resource hog! ~ ~ <http://www.sunbeltsoftware.com/Business/VIPRE-Enterprise/> ~ --- To manage subscriptions click here: http://lyris.sunbelt-software.com/read/my_forums/ or send an email to listmana...@lyris.sunbeltsoftware.com with the body: unsubscribe ntsysadmin
