Dear Paul,
I used to flash the programmer by Arduino IDE because I am used to work in
Arduino IDE (all my software uses Arduino libraries and they worked fine)
normaly the Atmel ICE appeared as a port.
Suddenly on all my computers the Atmel ICE is not there as a programming port??
On Wed, Nov 20, 2019 at 06:23:43PM -0000, Andries Oyens wrote:
openocd command gives:
...
Info : at91samd21e18.cpu: hardware has 4 breakpoints, 2 watchpoints
So the adapter is working just fine, what's the problem? And why do
you need any IDE to flash the target?..
--
Be free, use free (http://www.gnu.org/philosophy/free-sw.html) software!
mailto:[email protected]
________________________________
[tickets:#258]<https://sourceforge.net/p/openocd/tickets/258/> sudo apt install
openocd
Status: new
Milestone: 0.9.0
Labels: openOCD arduino no port
Created: Wed Nov 20, 2019 12:22 PM UTC by Andries Oyens
Last Updated: Wed Nov 20, 2019 06:23 PM UTC
Owner: Paul Fertser
Dear people,
I used to program with arduino ade SAMD21 boards (as a ArduinoZero) with Atmel
SAM-ICE. Suddenly the Arduino IDE does no see the Atmel SAM-ICE programmer on a
USB port.
typing openocd in terminal finds the programmer and connected board.
What can I do to find the programmer in the Arduino IDE?
kind regards, Andries
________________________________
Sent from sourceforge.net because you indicated interest in
https://sourceforge.net/p/openocd/tickets/258/
To unsubscribe from further messages, please visit
https://sourceforge.net/auth/subscriptions/
---
** [tickets:#258] sudo apt install openocd**
**Status:** new
**Milestone:** 0.9.0
**Labels:** openOCD arduino no port
**Created:** Wed Nov 20, 2019 12:22 PM UTC by Andries Oyens
**Last Updated:** Wed Nov 20, 2019 06:23 PM UTC
**Owner:** Paul Fertser
Dear people,
I used to program with arduino ade SAMD21 boards (as a ArduinoZero) with Atmel
SAM-ICE. Suddenly the Arduino IDE does no see the Atmel SAM-ICE programmer on a
USB port.
typing openocd in terminal finds the programmer and connected board.
What can I do to find the programmer in the Arduino IDE?
kind regards, Andries
---
Sent from sourceforge.net because [email protected] is
subscribed to https://sourceforge.net/p/openocd/tickets/
To unsubscribe from further messages, a project admin can change settings at
https://sourceforge.net/p/openocd/admin/tickets/options. Or, if this is a
mailing list, you can unsubscribe from the mailing list.
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
