Abd ulRahman,
Anyone know how to import a schematic from TANGO SCH to Protel?
Also, how about from TANGO PCB to Protel?
I know of no way to convert Tango SCH. We can do Tango design if
necessary. I think. It has been quite a while.
Tango PCB can be imported into Protel using Protel 2.8. I did it quite a
few times.
I think Bill also has PCad 2K, so there is a possibility here.
PCad2K also imports Tango PCBs, even better than Protel 2.8 (on polygons).
PCad2K also imports Tango ASCII schematics, the trick here is to have the
complete Tango schematic library, then you have to use Library Executive to
import the Tango Library to the PCad format, setup the library in the PCad
schematic program, and then import the Tango schematic.
Hope this helps.
Best Regards,
Paulo Egon
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
