At 04:10 AM 5/12/2006, Leo Potjewijd wrote: >Actually, there is a way around this in P99SEsp6. > >Create a DRC rule that specifically states that the clearance between any >two objects of the footprint <company logo> is 0 mil. >Next, also create a DRC rule that says the minimum track width of the >footprint <company logo> is 1 mil and you're all done.
It would also be possible to assign a net to the tracks. All it takes is a pad with that net, covered over or in contact with the tracks. Another solution would be to use copper-layer keepouts and put the logo tracks on a mech layer, which is merged according to the photoplot setups. But the solution given by Leo may be the best one. ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
