Bob, I have Altium Designer 6.7 up and running. In a pinch I could try loading your DXP design into AD6.7 and than save it as file version 4. However, I haven't done this a lot and so cannot vouch that everything would make it through intact. You'd still have to look it over in P99SE. I think it would be better if you could go directly from DXP to P98SE as they are much more closely related.
----- Original Message ----- From: "Steve Smith" <[EMAIL PROTECTED]> To: "Jeff Condit" <[EMAIL PROTECTED]>; "Protel EDA Discussion List" <[email protected]> Sent: Monday, September 10, 2007 9:43 AM Subject: RE: [PEDA] DXP PCB -> 99SE > Good luck with that. The primary reason we upgraded to DXP from 99SE was > that we had an outside source do a design for us in DXP and when we > brought them back into 99SE we had major problems with the file being > readable by 99SE. It literally took many multiple attempts to open the > file in 99SE, if it would open at all. > > > Regards, > Steve Smith > Product Engineer > Staco Energy Products Co. > Web Site: www.stacoenergy.com > & www.stacopower.com > > DISCLAIMER AND/OR CONFIDENTIALITY NOTICE: > This message, including any attached materials, is intended solely for > the use of the individual or entity to whom it is addressed and may > contain information that is privileged, confidential, and exempt from > disclosure under applicable law. If the reader of this electronic mail > transmission is not the intended recipient, you are hereby notified that > any dissemination, distribution, or copying of this communication is > strictly prohibited. If you have received this communication in error, > please e-mail or call Staco Energy Products Co. at (937) 253-1191. Thank > you for your cooperation. > > > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > On Behalf Of Jeff Condit > Sent: Monday, September 10, 2007 11:11 AM > To: [EMAIL PROTECTED]; Protel EDA Discussion List > Subject: Re: [PEDA] DXP PCB -> 99SE > > Robert, > > I don't have DXP up right now but believe P99SE files are version 4. > Can you try doing a Save-As to version 4? > > ----- Original Message ----- > From: "Robert Gillatt" <[EMAIL PROTECTED]> > To: "'Protel EDA Discussion List'" <[email protected]> > Sent: Monday, September 10, 2007 7:40 AM > Subject: [PEDA] DXP PCB -> 99SE > > >> Hi, >> Does anyone know if I can save DXP .pcbdoc files in a format that > 99SE >> will >> recognize. I know, I am a lazy man, but it might save me trying out > all >> the >> variations on the Save As menu. >> >> Thanks >> Rob >> >> R`theta Electronics >> >> <mailto:[EMAIL PROTECTED]> >> > > > > -- > No virus found in this incoming message. > Checked by AVG. > Version: 7.5.485 / Virus Database: 269.13.13/998 - Release Date: 9/10/2007 > 8:48 AM > > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[EMAIL PROTECTED] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
