I have been editing a layout (in DXP2004) and I have removed and replaced a polygon plane on the bottom layer several times, recreating it to move its edges and accommodate other component changes. It is set up to be connected to the ground net, and set to pour over same nets.
Previously it has worked fine, but now when I place the polygon plane, it shows only a trace outlining the area I selected, and it does not fill in at all. If I select the plane, it highlights and looks correct (there are openings around unconnected pads, etc.) and I can drag it, but when it's unselected it reverts to just an outline. Clearly something changed, but I have not had any luck discovering what I did. Any help would be appreciated. Thanks. Stan Stanley Levy Engineer L-Band Systems Arcadia, CA 91006 626-574-7394 ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[EMAIL PROTECTED] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
