Could you give a specific test case:
- function to run
- which PDL shell are you using
I just realized that Devel::REPL was not installed.
pdl2 does in fact print an error message (takes about
4 seconds to start.) So it is pdl 1, then...
-------------------------------
1 > pdl
perlDL shell v1.354_001 ...
ReadLines, NiceSlice, MultiLines enabled...
Reading PDL/default.perldlrc...
Loaded PDL v2.4.10 (supports bad values)
Note: AutoLoader not enabled ('use PDL::AutoLoader' recommended)
pdl> sub t { barf "Hello World" }
pdl> t
pdl>
-------------------------------
1 > perldl
perlDL shell v1.354_001
...
pdl> sub t { barf "Hello World" }
pdl> t
-------------------------------
John
_______________________________________________
Perldl mailing list
[email protected]
http://mailman.jach.hawaii.edu/mailman/listinfo/perldl
