Still no clue what it going on but I did
discover that if I use carp directly (from
use Carp) then I get the backtrace. However,
confess, croak, and die are "no shows".
--Chris
On 7/15/2012 10:56 AM, chm wrote:
I just tried this on my cygwin/XP PDL-2.4.11_001
(i.e., my latest devel) and the error did get
printed. I then tried on a SPP PDL-2.4.11 and
the barf was silent. I'm trying a clean build
of the latest git to investigate further.
--Chris
On 7/10/2012 2:03 PM, John Lapeyre wrote:
Could you give a specific test case:
- function to run
- which PDL shell are you using
I just realized that Devel::REPL was not installed.
pdl2 does in fact print an error message (takes about
4 seconds to start.) So it is pdl 1, then...
-------------------------------
1 > pdl
perlDL shell v1.354_001 ...
ReadLines, NiceSlice, MultiLines enabled...
Reading PDL/default.perldlrc...
Loaded PDL v2.4.10 (supports bad values)
Note: AutoLoader not enabled ('use PDL::AutoLoader' recommended)
pdl> sub t { barf "Hello World" }
pdl> t
pdl>
-------------------------------
1 > perldl
perlDL shell v1.354_001
...
pdl> sub t { barf "Hello World" }
pdl> t
-------------------------------
_______________________________________________
Perldl mailing list
[email protected]
http://mailman.jach.hawaii.edu/mailman/listinfo/perldl
