On Tue, Jul 10, 2012 at 2:03 PM, John Lapeyre
<[email protected]> wrote:
>
>> Could you give a specific test case:
>> - function to run
>> - which PDL shell are you using
>
> I just realized that Devel::REPL was not installed.
> pdl2 does in fact print an error message (takes about
> 4 seconds to start.) So it is pdl 1, then...
There is no pdl 1, it is perldl (although to support
unix script file syntax, pdl is a binary executable
which runs perldl).
As for the 4 seconds to load... a Moose is a *big* animal. :-)
> -------------------------------
> 1 > pdl
> perlDL shell v1.354_001 ...
> ReadLines, NiceSlice, MultiLines enabled...
> Reading PDL/default.perldlrc...
> Loaded PDL v2.4.10 (supports bad values)
> Note: AutoLoader not enabled ('use PDL::AutoLoader' recommended)
>
> pdl> sub t { barf "Hello World" }
>
> pdl> t
>
> pdl>
> -------------------------------
>
> 1 > perldl
> perlDL shell v1.354_001
> ...
>
> pdl> sub t { barf "Hello World" }
>
> pdl> t
_______________________________________________
Perldl mailing list
[email protected]
http://mailman.jach.hawaii.edu/mailman/listinfo/perldl
