Are there any good channel strip plugs that will work with VO and PT. It
seems that most of the waves stuff is for native setups, but maybe I have
that wrong. I would just like to get something better than the stock eq's
and compressor. The factory plug-ins have been around since pt6 and maybe
earlier than that. The bomb factory compressor is a bit better, but it
would be nice to have a strip with comp/eq/tube distortion etc.
Gord
-----Original Message-----
From: Slau Halatyn
Sent: Sunday, October 16, 2011 11:20 AM
To: [email protected]
Subject: Re: Master Tracks?
No worries, I didn't take it that way at all. It's definitely an aspect of
using the master track that one should consider. At this point, I think the
issue of pre versus post fader compression is beyond the question when
someone is just trying to get their head around Pro Tools in general,
that'sl all.
Cheers,
Slau
On Oct 16, 2011, at 11:03 AM, Stephen Martin wrote:
I do agree with you, and i do apologize if i came off as trying to correct
you or saying you shouldn't put a compressor on the master track. It was
intended more as a suggestion or tip that i came across in my own journey
in learning more about PT, and figured i'd would share another way of
doing it with the list.
On Oct 16, 2011, at 10:49 AM, Slau Halatyn wrote:
As with most things, there's more than one way to accomplish a task and
this is one of them. Some people put compressors on the master track,
some don't. I'm simply illustrating one of its uses.
Slau
On Oct 16, 2011, at 10:02 AM, Stephen Martin wrote:
I have read in a few places where they don't always recommend putting a
master compressor on the master track, since the master track unlike all
the other tracks in pro tools has the fader before the inserts and
sends, which means if u put a compressor on the master track, set it up
how u like, then later adjust the master fader, it will pretty much
cause you to have to go redo the compressor settings. A work around is
to create a sub mimix aux track and send all your tracks to that, add
all your master effects on that track and output that to the master
track.
On Oct 16, 2011, at 9:54 AM, Slau Halatyn wrote:
Christopher,
Master tracks control the output level being fed to an output bus. Most
often, a master track will control the main left and right outputs for
a stereo mix. It's not necessary to necessarily use a master track for
a regular mix but it certainly does help to create a master track to
see the combined level of all of the individual tracks on the master
track's level meter. Further, when putting bus compression over an
entire mix, it would normally be done with a compressor plug-in on a
master track. Finally, master tracks are used when creating stems for
surround mixes, alternate mixes, instrumental versions, etc. Again,
most people just use a single master track for overall mix purposes.
HTH,
Slau