At 10:41 PM 6/3/2004 -0400, you wrote: >how about another way take the screws out the bottom punch out the epoxy run >a tap through to clean up the threads then make some new screws out of 10X32 >1" long machine screw by cutting the heads off and putting a cut in the top >for a screw driver so that you can tune them up.
<---I'm not sure there is enough room inside to get a beefy enough pair of needle nose in there to do that but maybe there is. I guess replacing the screws entirely would work, as they looked like plated steel to me but I might be wrong about that.. Ken ------------------------------------------------------------------------------ President and CTO - Arcom Communications Makers of state-of-the-art repeater controllers and accessories. http://www.ah6le.net/arcom/index.html AH6LE/R - IRLP Node 3000 http://www.irlp.net Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
