Problem is that they are licensed for 3 freqs. 2 UHF and 1 VHF and I have 
confirmed that they are running on all three of them.  Its just know a matter 
of cat and mouse on the third repeater location.  As there is no one that works 
here anymore that knows where the radios are all located expect the 2 at the 
high school football field.

In fact the bus repeater as listed on its license is supposed to be located 
right in the middle of the intersection of a state highway and a US highway 
that runs through our town, while the GPS listed on the same license shows it 
to be about 20 miles south of that location in the middle of a cow pasture.

Will keep seeking, thanks for the help and input.

Chris KE5IGO

--- In Repeater-Builder@yahoogroups.com, "Maire-Radios" <maire-rad...@...> 
wrote:
>
> how about one repeater but different tone codes?
> 
> or the repeater is at some other location.
> 
> John
>   ----- Original Message ----- 
>   From: Christopher Hodgdon 
>   To: Repeater-Builder@yahoogroups.com 
>   Sent: Thursday, August 13, 2009 8:43 PM
>   Subject: [Repeater-Builder] Re: Motorola MTR2000 Question
> 
> 
>     I wish I had a picture of the repeater house. The frequency listed on the 
> MTR2000 is that of the schools maint. department. The other MTR2000, hook to 
> the other antenna, is the Schools PD. I know those for a fact. Now its time 
> to locate the other repeater system. 
> 
>   The only odd ball thing I do know is that every once in a while, when a bus 
> is talking to another bus or dispatch, you get a high squeal walk on over 
> them, but its most likely another drive not paying attention and trying to 
> key their radio. But I wonder if it might be the maint. since their frequency 
> is so close to ours.
> 
>   --- In Repeater-Builder@yahoogroups.com, "Gary" <n6lrv@> wrote:
>   >
>   > The UHF repeater is likely mismarked or the frequency info you obtained 
> for
>   > your school's license is inaccurate. The UHF repeater is likely the 
> school's
>   > repeater. As mentioned earlier the MTR2000 is a multi-channel radio but 
> can
>   > only repeat on the channel it is left on. Recommend you find a dealer or
>   > tech experienced with the MTR and who has the software necessary to
>   > configure it. Have them download its codeplug. Recommend you do the same
>   > with your school radios. A comparison of the data will likely answer a 
> lot.
>   > Gary
>   > 
>   > -----Original Message-----
>   > From: Repeater-Builder@yahoogroups.com
>   > [mailto:repeater-buil...@yahoogroups.com] On Behalf Of Christopher Hodgdon
>   > Sent: Thursday, August 13, 2009 4:29 PM
>   > To: Repeater-Builder@yahoogroups.com
>   > Subject: [Repeater-Builder] Re: Motorola MTR2000 Question
>   > 
>   > Here's the deal, I work for a local school district, I have been kind of
>   > thrust into a temp. communications specialist position while we obtain 
> some
>   > new buses and working with the company that will be adding the new radios 
> to
>   > them.
>   > 
>   > Over the last few weeks, we have been trying to determine the location of
>   > our repeater. The place were it is listed on the FCC license paperwork 
> does
>   > not exist. I know, I am pushing them to get it updated. But that is
>   > another story all together.
>   > 
>   > I do have access to a "radio house" located at our high school football
>   > field and it has two MTR2000 in it, plus two different antennas. One
>   > connected to one radio and one connected to the other.
>   > 
>   > One radio is marked with the description of KISD PD, which is our police
>   > department for the district and has the following frequency pair listed on
>   > it:
>   > 
>   > VHF: RX 173.325 DPL 331 and TX 158.385 DPL 331
>   > 
>   > The other radio is marked the following:
>   > 
>   > UHF: 451.725 / 456.725
>   > 
>   > There is no documentation with this equipment, the person incharge of them
>   > originally left the district some years ago and no one knows anything 
> about
>   > them, expect where they are located, as far as these two boxes go and what
>   > frequencies that have listed.
>   > 
>   > 
>   > Which brings me back to our department, we can find out repeater located
>   > anywhere physcially. Our repeater pair is listed as:
>   > 
>   > UHF: 451.750 / 456.750
>   > 
>   > That is according to FCC, repeater listing and other information I have 
> been
>   > able to obtain and by listening to it on a UHF amateur radio to see which
>   > frequency they were on.
>   > 
>   > That being said, it is possible that the MTR2000 that is marked with the 
> one
>   > UHF frequency, might actually have both pairs programmed into it, but only
>   > one can run at a time, right?
>   > 
>   > Is there a way to find out if there is more than one frequency is 
> programmed
>   > into the unit and if so, how might we go about that? Another reason I am
>   > asking is that we might be upgrading our system in the very near future 
> and
>   > I might be able to get my hands on these repeaters.
>   > 
>   > Thanks in advance.
>   > 
>   > --- In Repeater-Builder@yahoogroups.com, Brian Raker <brian.raker@>
>   > wrote:
>   > >
>   > > The radio can be programmed for multiple frequency pairs. That being
>   > > said, it cannot operate more than one channel / programmed pair of
>   > > frequencies at one time.
>   > > 
>   > > -Brian / KF4ZWZ
>   > > 
>   > > On Thu, Aug 13, 2009 at 3:23 PM, Christopher
>   > > Hodgdon<chris.hodgdon@> wrote:
>   > > > This is a question I have been asked and don't have an answer for.  
> This
>   > could be for either amateur operation or commercial operation, but it
>   > relates to the repeater itself.
>   > > >
>   > > > Can a Motorola MTR2000 setup on UHF be setup to function as a repeater
>   > on more than one pair of frequencies?  I know looking at the brochure on 
> the
>   > website, it says that the NO. of Frequencies are upto 32.
>   > > >
>   > > > Does that mean it can handle two different sets of repeater pairs at 
> the
>   > same time in the same radio?
>   > > >
>   > > > These are commercial frequencies I am listed at commercial, but they 
> are
>   > for example purposes:
>   > > >
>   > > > Can the following setup work with the MTR2000?
>   > > >
>   > > > Frequency Pair 1: 451.725/456.725
>   > > > Frequency Pair 2: 451.750/456.750
>   > > >
>   > > > Can one MTR2000 handle both of these at the same time?
>   > > >
>   > > > Thank in advance.
>   > > >
>   > > >
>   > > >
>   > > > ------------------------------------
>   > > >
>   > > >
>   > > >
>   > > > Yahoo! Groups Links
>   > > >
>   > > >
>   > > >
>   > > >
>   > >
>   > 
>   > 
>   > 
>   > 
>   > ------------------------------------
>   > 
>   > 
>   > 
>   > Yahoo! Groups Links
>   >
>


Reply via email to