On a slightly different note, if you have problems with different
levels with different audio cards for different programs, take a look at
this program:
http://www.romacsoftware.com/SoundManagement.htm
Very clever. It detects what program you are using and what audio card
is requested and res
Bill W5WVO wrote:
>
>
> I'm about to set up my K3 with my computer sound card for WSJT
> (DATA A mode) operation. You seem to imply above that it is
> necessary to retweak the Mic Gain / Line In control every time you
> go from SSB to DATA A and vice-versa. I would think the setting
> for Line
- Original Message -
From: "Lynn Lamb, W4NL" <[EMAIL PROTECTED]>
To: "Elecraft Reflector"
Sent: Saturday, December 06, 2008 7:00 AM
Subject: [Elecraft] K3 and the digital modes
> ... Once I figured out that 'line in' had a gain
> control automa
Thanks,
For the many who responded to my question on hook-up for the K3 using the
digital modes, THANKS.
It works with MixW using the two cables from the in/out of the K3 to the
mic/speaker on the computer along with a serial cable for rig control. Once
I figured out that 'line in' had a ga
On Thu, 4 Dec 2008 18:37:06 -0500, Lynn Lamb, W4NL wrote:
>I expected this same cable to give
>me all the audio in and out plus key the rig.
No, it only does serial control, and you need that for RTTY. To that
you must add input and output connections to/from your computer
sound card and the
Lyle KK7P wrote:
PS - I would expect FLdigi and MixW to work as well, but have not
tried them so cannot speak from experience.
fldigi works well with the K3 on Windows and Linux. I haven't tried it
on MacOS but I'm told it works.
The RigCat XML interface for rig control works FB with it as
Lynn,
Connect the computer *soundcard* input to the K3 rear panel Line Out,
and the computer Line out to the K3 Line IN jack. Use two stereo cables
with a 3.5mm stereo plug on each end (the plugs must be stereo even if
the signal is in only one channel - typically the left channel).
You can
Guess I misunderstood how the K3 did this and purchased the serial to
USB cable at the time the K3 was ordered and it does the trick relative
to downloading the firmware and very well. I expected this same cable
to give me all the audio in and out plus key the rig...
No, it is just a serial
Lynn Lamb, W4NL wrote:
Pardon for a dumb question, but I've hit that wall... again!
I talked to Dale at Elecraft and he suggested some of you may know the
answer as he had no experience with hooking up and making K3 work with a
computer so it will work using the sound card to have a full arr
Connect Line In / Line Out on K3 and the Line In / Line Out on the sound
card and away you go.
73,
Ken K3IU
Lynn Lamb, W4NL wrote:
Pardon for a dumb question, but I've hit that wall... again!
I talked to Dale at Elecraft and he suggested some of you may know the
answer as he had no experience
Pardon for a dumb question, but I've hit that wall... again!
I talked to Dale at Elecraft and he suggested some of you may know the
answer as he had no experience with hooking up and making K3 work with a
computer so it will work using the sound card to have a full array of modes,
etc.
Guess
11 matches
Mail list logo
