...reading the Cisco Press Support Book. They talked about the 'show
controllers' command. My question is when and why would you use this
command? I read that the output can be overwhelming, and that some of the
information is irrelevant! Go figure!. But again, when would you need the
information
I think the most common usage would be during setup or troubleshooting
you can use 'show controllers serial ' to see if a particular
interface has a DCE or DTE cable connected. If it's DCE that command
will also show you the current clockrate.
Regards,
John
>>> "Watson, Rick, CTR, OUSDC" 6/14/
ailto:[EMAIL PROTECTED]]
Sent: Thursday, June 14, 2001 10:10 AM
To: [EMAIL PROTECTED]
Subject: 'show controllers' command [7:8528]
...reading the Cisco Press Support Book. They talked about the 'show
controllers' command. My question is when and why would you use this
command? I
it's good stuff when troubleshooting atm. gives you clokc source and what
type of errors you are receiving
>>> "Watson, Rick, CTR, OUSDC" 06/14/01 11:09AM >>>
...reading the Cisco Press Support Book. They talked about the 'show
controllers' command. My question is when and why would you use thi
t;
>Reply-To: "Lowell Sharrah" >To: [EMAIL PROTECTED] >Subject: Re: 'show
controllers' command [7:8528] >Date: Thu, 14 Jun 2001 11:48:10 -0400 >
>it's good stuff when troubleshooting atm. gives you clokc source and
what >type of errors you are re
%
CY1Bus utilization for five seconds: 13%; one minute: 13%; five minutes: 13%
You would use this to help you load balance the buses.
Kevin Wigle
- Original Message -
From: "Watson, Rick, CTR, OUSDC"
To:
Sent: Thursday, 14 June, 2001 11:09
Subject: 'show controllers' com
ge -
From: "Watson, Rick, CTR, OUSDC"
To:
Sent: Thursday, June 14, 2001 10:09 AM
Subject: 'show controllers' command [7:8528]
> ...reading the Cisco Press Support Book. They talked about the 'show
> controllers' command. My question is when and why would
t;Reply-To: "Watson, Rick, CTR, OUSDC"
>To: [EMAIL PROTECTED]
>Subject: 'show controllers' command [7:8528]
>Date: Thu, 14 Jun 2001 11:09:58 -0400
>
>...reading the Cisco Press Support Book. They talked about the 'show
>controllers' command. My quest
8 matches
Mail list logo