Can Use Floating routes to do the Load balancing on the Links.
giving different metrics to each Link.
Namish
MCSE,CCNA,CCNP
Rashid Lohiya :
> Just out of curiosity, would 2 static routes with same metrics not do
> the
> trick?
> One packet out one interface and the other out the 2nd?
> Not su
Hi Rashid,
Static routes will not be efficient in terms of sharing the load of the 2
E1 links. If one of the network connecting to link1 generates more traffic
than the other link, then it defeats the purpose of commissioning another
new 2Mbps to sharing the congestion.
Regards,
Cheeyong
At
> All your questions regarding these kinds on set ups are answered in this
> book
> Good luck.
> Tony M.
> #6172
>
> - Original Message -
> From: Michael L. Williams
> To:
> Sent: Sunday, June 10, 2001 11:03 AM
> Subject: Re: Load Sharing of 2 Serial on
this book a lot for referencing. The ISBN # is 0-201-37950-1
All your questions regarding these kinds on set ups are answered in this
book
Good luck.
Tony M.
#6172
- Original Message -
From: Michael L. Williams
To:
Sent: Sunday, June 10, 2001 11:03 AM
Subject: Re: Load Sharing of 2 Se
Hi Remmert,
I thought you could use HSRP to load balance as well as for redundancy..
Here's an link showing how to set this up
http://www.cisco.com/warp/public/619/7.html
However, using HSRP for load sharing is only useful in certain
situations..
Mike W.
"Remmert Veen" wrote
Just out of curiosity, would 2 static routes with same metrics not do the
trick?
One packet out one interface and the other out the 2nd?
Not sure, just wondering! Or will only the first static get all the packets?
Rashid Lohiya
[EMAIL PROTECTED]
020 8509 2990
07785 362626
www.pioneer-computers.co
Hi Remmert,
Thank you for your advise. Below is the updated network diagram.
(10.10.10.1/24)
| E0
-
| Cisco 2501 R1 |
---
if you are running ppp encapsulation over those two lines (which you should
consider) you can run a multilink (go to cco and do search on configuring
virtual templates), and have a full pipe of 3 mb.
other way is to run one of the routing protocols, whichever you want.
Dragi
Message Posted at:
"Your network diagram unfortunately isn't too clear. From which network to
which network do you want to load-balance? "
What is this supposed to mean?
Dragi
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=7723&t=7687
--
FAQ, list
Hi Cheeyong,
HSRP indeed won't do the trick, this is a redundancy mechanism.
To enable load-sharing, check what routing protocol you are running. OSPF
and EIGRP are able to do equal-cost load-sharing by default. If the 2 serial
links are unequal cost, I'd recommend EIGRP to provision unequal-co
Hi all,
I would like to perform load sharing 2 serial links on a Cisco 2501, how
should I go about doing that?? I had thought of using HSRP, but I think it
is not applicable in this scenario. Any advise?? Below is the network
diagram.
(10.10.10.1/24)
11 matches
Mail list logo
