i got 3 routers connected by R1 as a framerelay switch ,
using s1/0 on R1 to connect with s1/0 on R2,s1/1 on R1 to connect with s1/0
on R3.
According to some materials,
i should config such on R1:
frame-relay switching
int s1/0
no ip address
encap frame
clock rate 64000
frame intf-type dce
fram
.
Have fun!
Chuck
-Original Message-
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of
Frank
Sent: Monday, November 27, 2000 6:10 PM
To: [EMAIL PROTECTED]
Subject:how to config a frame relay switch?
i got 3 routers connected by R1 as a framerelay switch ,
using
yeah ,i got a type mistake in config of int s1/1,i have corrected it.
the config on dte is quite simple ,i think.
It's as follows:
R2:
interface Serial1/1
ip address 172.16.40.1 255.255.255.0
encapsulation frame-relay
router ospf 1
network 172.16.0.0 0.0.255.255 area 0
R3:
interface Serial1/1
R1 is acting as the telco side of the frame-relay switch. It
doesn't/shouldn't care about any layer 3 protocols, just it's DLCI mappings
between interfaces.
--
Jason Roysdon, CCNA, MCSE, CNA, Network+, A+
List email: [EMAIL PROTECTED]
Homepage: http://jason.artoo.net/
Cisco resources: http://r2c
4 matches
Mail list logo