|
You should not do lie testing until you can use the shaft the
player is going to play with.
llhack
----- Original Message -----
Sent: Sunday, March 09, 2003 7:39
PM
Subject: Re: ShopTalk: best dynamic
fitting
Alan,
With the usual caveat of all other things being equal,
the Balistik is drooping and you need about 2 degrees toe up on it. The
usual accepted method is to find the center of the club by finding the half
way point of the score lines. Mark that point and swing away. Not
the center of the scuff marks, measure from the marked center point and
adjust. Yes, stronger swing speeds will cause more
droop.
Al
At 08:41 PM 3/9/2003, you wrote:
What is
the best way to do a dynmaic fitting. I ask because I have the golfsmith
fitting iron that is 60 degree and 38 inch five iron. In this I have a
Balistik shaft at the regular flex using the old software. I also a snake
eyes viper that was hand picked to 60 and is 38 inches. I have an apache
pm30 at R3. What I find is that with the Golfsmith fitting iron I hit a1/2
inch toward the toe. The viper, I hit in the middle or what I would see as
the centre bottom. Should there be a difference or is the Balistik drooping
too much. I'm wondering, for stronger swing speeds, if this causes more
droop in the shaft leading to incorrect lie measurements.
Alan
|
